James Hardie Stucco Panel Siding Installation

Alternatively the panels can be installed over wood sheathing covering foam insulation of 1 inch thick or less.

James hardie stucco panel siding installation.

After installing the lower course of james hardie stucco panel siding install vinyl or coated aluminum z flashing at the top edge of the stucco panel. Irregularities in framing and sheathing can mirror through the finished application. Hardiepanel vertical siding is available as a prefinished james hardie product with colorplus technology. Learn how to install hardiepanel vertical siding products.

The colorplus coating is a factory applied oven baked finish available on a variety of james hardie siding and trim products. We have dozens of installation specialists throughout the u s. James hardie offers an array of siding products. As america s 1 brand of siding james hardie fiber cement siding and trim bring beautiful design and superior performance to homes from coast to coast.

Hardieplank lap siding hardieshingle siding hardiepanel vertical siding hardietrim boards hardiesoffit pre cut panels artisan by james hardie hardiewrap weather barrier hardiebacker cement board. Please see your local james hardie dealer for texture and size availability. As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology. Of panel siding install vinyl or coated aluminum z flashing at the top edge of the panel.

This gap should never. Make sure the flashing is sloped away from the wall. Refer to table 1 for james hardie s multifamily commercial drainage requirements. Install the second level or gable stucco panels leaving a 1 4 minimum gap between the bottom of the stucco panel and the z flashing.

Browse the photos below to see james hardie products on real hardie homes. Install hardiepanel stucco finish vertical siding over horizontal and vertical braced wood or steel wall studs spaced a maximum of 24 inches on center. Hardiepanel vertical siding can be installed over braced wood or steel studs spaced a maximum of 2 ft. Install the second level or gable panels leaving a 1 4 in.

Minimum gap between the bottom of the panel and the z flashing.